A node module for reading temperature and humidity using T9602 sensor on Raspberry Pi.
This module has only been tested on Raspbery Pi 4 Model B 4 GiB running on Raspberry PI OS.
I'm not aware of all the products differences and I'm not planning on testing this module on other products myself.
Don't hesitate to tell me about your attempts on other products.
| Model | Supported |
|---|---|
| Raspberry Pi A | ❓ |
| Raspberry Pi B | ❓ |
| Raspberry Pi A+ | ❓ |
| Raspberry Pi B+ | ❓ |
| Raspberry Pi 2 B+ | ❓ |
| Raspberry Pi Zero Zero | ❓ |
| Raspberry Pi Zero W/WH | ❓ |
| Raspberry Pi 3 B | ❓ |
| Raspberry Pi 3 A+ | ❓ |
| Raspberry Pi 3 B+ | ❓ |
| Raspberry Pi 4 B 1GiB | ❓ |
| Raspberry Pi 4 B 2GiB | ❓ |
| Raspberry Pi 4 B 4GiB | ✔ |
| Raspberry Pi 4 B 8GiB | ❓ |
| Raspberry Pi 4 B 400 | ❓ |
Here is how I connected my t9602 sensor on my Rpi 4 B following the sensor pin design :
- V+ (red cable) on 3.3V
- Ground (green cable) to any Ground Pin
- SDA (white cable) on SDA1 (GPIO2)
- SCL (black cable) on SCL1 (GPIO3)
Refer to the official Raspberry Pi 4 Model B datasheet if necessary.
- Don't forget to enable I2C with
sudo raspi-configand reboot. npm install node-t9602- Check examples folder if needed.