ftrm-gpio

Footurama Package: GPIO

With this package you can access your GPIOs using the Linux gpio sysfs driver.

ftrm-gpio/in

Read from a GPIO.

Configuration:

• input: 0.
• output: 1. Target pipe for read values.
• gpio: The GPIO's pin number.
• invert: If set to true HIGH will get false and LOW will get true. Default: false.
• interval: If set, the input will be read in an interval of the given number of milliseconds.
• watch: Emit values if an edge is detected on the input. Default: true

Example:

// Read from GPIO 23 every second
module.exports = [require('ftrm-gpio/in'), {
    output: 'output-pipe-with-booleans',
    gpio: 23,
    interval: 1000
}];

ftrm-gpio/out

Read from a GPIO.

Configuration:

• input: 0.
• output: 1. Target pipe for read values.
• gpio: The GPIO's pin number.
• invert: If set to true the GPIO will be put into active LOW mode. Default: false.
• default: If set, the input will be read in an interval of the given number of milliseconds.

Example:

// Set the output of GPIO 23 to the values according to the input pipe.
// If no values are received within 5 minutes, the default will be set.
module.exports = [require('ftrm-gpio/out'), {
    input: [{pipe: 'input-pipe-with-booleans', expire: 5 * 60 * 1000}],
    default: true
    gpio: 23
}];