homebridge-xiaomi-purifier-3

Features

• Switch on / off.

• Switch auto / manual mode.

• Change fan rotation speed.

• Switch child lock on / off.

• Switch LED light on / off.

• Switch buzzer sound on / off.

• Display temperature.

• Display humidity.

• Display air quality.

• Display filter state.

Installation

1. Install required packages.

    npm install -g homebridge-xiaomi-purifier-3
    ```

2. Make sure your Homebridge server is same network with your device, then run following command to discover the token.

miio discover --sync
```

1. You may need to wait few minutes until you get the response similar to below:

    Device ID: 49466088
    Model info: Unknown
    Address: 192.168.1.8
    Token: 6f7a65786550386c700a6b526666744d via auto-token
    Support: Unknown
    ```

4. Record down the `Address` and `Token` values as we need it in our configuration file later.

5. If you are getting `??????????????` for your token value, please reset your device and connect your Homebridge server directly to the access point advertised by the device.

6. Then run the command again.

miio discover --sync
```

1. Add following accessory to the config.json .

        "accessories": [
            {
                "accessory": "MiAirPurifier3",
                "name": "Bed Room Air Purifier",
                "ip": "192.168.1.x",
                "token": "xxxxxxxxxxxxxxxxxxx",
                "did": "xxxxxxxxx",		 
                "enableLED": true (optional),
                "enableLEDName": "Some custom LED name" (optional),
                "enableBuzzer": true (optional),
                "enableBuzzerName": "Some custom buzzer name" (optional),				
                "showTemperature": true,
                "showTemperatureName": "Some custom Temperature name" (optional),
                "showHumidity": true (optional),
                "showHumidityName": "Some custom Humidity name" (optional),
                "showAirQuality": true (optional),
                "showAirQualityName": "Some custom Air Quality name" (optional),
                "pm25_breakpoints": [5, 12, 35, 55] (optional),
                "polling_interval": 60000 (optional)
            }
        ]
    ```

    **Notes:** Set value for `enableLED` , `enableBuzzer` , `showTemperature` , `showHumidity` , `showAirQuality`  to **true** or **false** to show or hide these sensors in Home app.

8. Restart Homebridge, and your device will be added to Home app.

# License

MIT License