electron-johnny-five-servo-example

0.1.0 • Public • Published

3-servo

This app allows you to control a servo motor

Setting up the hardware

I used an arduino mega for this example, but any of the boards supported by johnny-five should work.

Connect a servo motor directly to pin 10

Setting up the code

To run, first clone the repo and npm install the example directory

git clone https://github.com/sofroniewn/electron-johnny-five-examples
cd electron-johnny-five-examples/3-servo
npm install

Unfortunately the serial port may not work right away and might need to be rebuilt

./node_modules/.bin/electron-rebuild

At this point if you try to starting the app with

npm start

You may get an error if the path to serialport.node is wrong

Uncaught Error: Cannot find module '/Users/sofroniewn/github/electron-johnny-five-examples/1-led/node_modules/johnny-five/node_modules/serialport/build/Release/node-v47-darwin-x64/serialport.node'

This can easily be fixed by

mv ./node_modules/johnny-five/node_modules/serialport/build/Release/electron-v0.36-darwin-x64/ ./node_modules/johnny-five/node_modules/serialport/build/Release/node-v47-darwin-x64/

You're now ready to run the app!

For more information about that error and using electron with johnny-five and node-serialport in general, check out this super helpful blog post by @noopkat

Running the app

After setting up the hardware and the code you are now ready to run the app with

npm start

Once the board has been found and the green status light in the top right has turned on, you should be able to control the servo by typing an angle into the input box in the top left corner. This servo has a range of 45° to 135°.

Congrats! Check out the next example 4-potentiometer

Dependents (0)

Package Sidebar

Install

npm i electron-johnny-five-servo-example

Weekly Downloads

1

Version

0.1.0

License

MIT

Last publish

Collaborators

  • sofroniewn