@rakwireless/ads7830

1.0.0 • Public • Published

@rakwireless/ads7830

A Node-RED node providing access to a ADS7830 I2C analog to digital converter.

version downloads

Install from Node-RED

From within NodeRED, visit the top right menu, select Manage palette and then the Install tab. Look for @rakwireless/ads7830 and install it.

Manual installation (development)

Please install @rakwireless/ads7830 node with the following commands. If you use docker of Node-RED, you may need to replace ~/.node-red with /usr/src/node-red.

git clone https://github.com/RAKWireless/node-red-nodes.git
cp -rf node-red-nodes/node-red-contrib-ads7830 ~/.node-red/node_modules
cd ~/.node-red/node_modules/node-red-contrib-ads7830 && npm install

Tips: After @rakwireless/ads7830 being installed, Node-RED should be restarted, otherwise, the node cannot be found on the page.

Usage

NOTE: Please make sure that user of system has the permissions to access i2c device, or you cannot get the result you want when use ads7830 node, the result will be empty.

To get a voltage or difference of voltage from a ADS7830 analog to digital converter just select the correct setting for your device and trigger the node.

image-20220309092410807

  • Name

    Define the msg name if you wish to change the name displayed on the node.

  • /dev/i2c-?

    Default I2C Bus is 1. 1 is for '/dev/i2c-1'.

  • i2c_Address

    The Address by default is set to 0x4A. You can setup the ADS7830 with one of four addresses, 0x48, 0x49, 0x4a, 0x4b. Please see ads7830 documentation for more information.

  • Inputs

    Inputs may be used for Single-ended measurements (like A0-GND) or Differential measurements (like A0-A1). Single-ended measurements measure voltages relative to a shared reference point which is almost always the main units ground. Differential measurements are “floating”, meaning that it has no reference to ground. The measurement is taken as the voltage difference between the two wires. Example: The voltage of a battery can be taken by connecting A0 to one terminal and A1 to the othe with Common-ground.

  • Internal Reference

    Open or close internal Reference in chip.

  • A/D Converter

    Open or close A/D Converter in chip.

Example

rak16001-read - Extend RAK16001 in RAK7391 board and test it with NodeRed.

License

This project is licensed under MIT license.

Package Sidebar

Install

npm i @rakwireless/ads7830

Weekly Downloads

3

Version

1.0.0

License

MIT

Unpacked Size

3.32 MB

Total Files

16

Last publish

Collaborators

  • xoseperez_rak