@legacymachine/node-red-contrib-shuttlexpress

node-red-contrib-shuttlexpress

Node-RED node for Contour Design's USB ShuttleXpress input device, built around shuttle-control-usb which uses node-hid and usb.

Note: Contour Design's ShuttlePro v1 and ShuttlePro v2 should work as well.

This node was created as a physical control option for a Grbl based CNC controlled machine but can be used generically for other user defined needs.

Install

Either use the Editor -> Menu -> Manage Palette -> Install option, or run the following command in your Node-RED user directory (typically ~/.node-red).

npm install @legacymachine/node-red-contrib-shuttlexpress

Prerequisites

ShuttleXpress device by Contour Design

Usage

This node parses the output buffer data from a Contour Design ShuttleXpress device. The parsed buffer data is output to msg.payload as an object containing cmd, value and id properties. If a device error occurs, it will be handled using node.error().

Output

    payload object

{cmd: BTN_#, value: boolean, id: device.id}

{cmd: MPG, value: -1 or 1, id: device.id}

{cmd: MPG-POSITION, value: 0 to 255, id: device.id}

{cmd: JOG, value: -7 to 7, id: device.id}

{cmd: JOG-TRANSITION, value: {current: -7 to 7, previous: -7 to 7}, id: device.id}

Output Details

BTN_# - returns true for button pressed, false for button released.

MPG - returns either -1 or +1 to reflect CCW (negative) or CW (positive) direction of the MPG (Manual Pulse Generator) dial.

JOG - returns integer values between -7 and 7 where 0 is the resting state of the jog dial, negative values are CCW and positive values are CW on the jog dial.

Linux Notes

Install the packages as shown below

sudo apt install build-essential libudev-dev

Visit the node-hid and usb repositories on GitHub for information on setup, and the prerequisites for various platforms (especially Linux) to get the node installed and working.

udev device permissions

Most Linux distros use udev to manage access to physical devices, and USB HID devices are normally owned by the root user. To allow non-root access, you must create a udev rule for the device, based on the devices vendorId and productId.

This rule is a text file placed in /etc/udev/rules.d.

For these Shuttle USB HID devices with vendorId = 0x0b33 and productIds = 0x0010, 0x0020, 0x0030, the rules file to support hidraw would look like:

SUBSYSTEM=="hidraw", ATTRS{idVendor}=="0b33", ATTRS{idProduct}=="0010", MODE="0666"

SUBSYSTEM=="hidraw", ATTRS{idVendor}=="0b33", ATTRS{idProduct}=="0020", MODE="0666"

SUBSYSTEM=="hidraw", ATTRS{idVendor}=="0b33", ATTRS{idProduct}=="0030", MODE="0666"

Note that the values for vendorId and productId must be in hex and lower-case.

Save this file as /etc/udev/rules.d/99-Shuttle.rules, unplug the HID device, and reload the rules with:

**Note: 99-Shuttle.rules File is included in GitHub repository

sudo udevadm control --reload-rules